IBM 2498-24E, Инструкция по установке, обслуживанию и эксплуатации

Страница: 53 / 80

Removing SFP modules
To remove an SFP:
1.
Press and hold the cable release
B
, as shown in section 1 of Figure 10
2. Remove the cable from the SFP, as shown in section 2.
3. Pull the bail (wire handle)
D
in section 3 to release the SFP.
4. Grasping it by the bail, gently but firmly pull the SFP (
C
in section 4) out of
the port.
Attention: If the SFP you are removing does not have a bail, use a small
implement such as a screwdriver to press the release trigger beneath the port.
Non-bailed SFPs can be damaged by the removal process and are not
recommended. Refer to http://www-01.ibm.com/support/
docview.wss?uid=ssg1S1004421 for a list of supported SFPs and devices.
5.
Repeat this procedure for the remaining ports, as required.
Item Description
A Switch chassis
B Cable release
C SFP
scale: 1/8" = 1"
!
IO
IO
I
AT
TE
N T
IO
N :
M
ax
im um
sc
re w
len
gt h
fo
r r
ac
k
m
ou
nti ng
to
b e
5m
m
or
1
3/
64
in
.
1
3
4 2
A
D
C
B
E
C
B24_0005
Figure 10. Removing an SFP
Chapter 3. Operating the switch
29