IBM 2292, Руководство по техническому обслуживанию аппаратной части

Страница: 10 / 230

DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to
002
.
If YES, proceed to
003
.
002
If the Power Management feature is enabled, do the following:
1. Start the Configuration/Setup Utility program. See “Setup Utility program” on
page 14.
2.
Select
Power Management
from the Configuration/Setup Utility program
menu.
3. Select APM .
4.
Be sure APM BIOS Mode is set to Disabled . If it is not, press Left Arrow (
}
) or
Right Arrow (Æ) to change the setting.
5. Select Automatic Hardware Power Management .
6. Set Automatic Hardware Power Management to Disabled .
7. If the problem persists, continue to
003
.
003
Run the Diagnostic programs. If necessary, refer to “Diagnostics” on page 16.
v
If you receive an error, replace the part that the diagnostic program calls out or
go to
″
Symptom-to-FRU Index
″
on page Chapter 7, “Symptom-to-FRU index,”
on page 47.
v
If the test stops and you cannot continue, replace the last device tested.
4
Hardware Maintenance Manual Types 2292, 2273, 6043, 6343, 6349, 6350, 6790, 6791, 6792, 6793, 6794, 6795, 6823, 6825