IBM 1454, Руководство по установке

Страница: 21 / 44

21
Install memory, firmware, or option cards
Installing a memory card
Follow the instructions in this section to install a printer memory card. Memory cards
must have 168-pin connectors.
Note:
Some memory options offered for
other printers cannot be used with your
printer. Refer to the publications CD for
memory specifications.
1
Remove the system board access cover (see page 20).
Warning:
Memory cards are easily
damaged by static electricity. Touch
something metal on the printer before
you touch a card.
2
Unpack the memory card.
Avoid touching the connection points along the edge of the card. Save the
packaging.
3
Push open the latches on both ends of the memory connector.
4
Align the notches on the bottom of the card with the notches on the connector.
5
Push the memory card firmly into the connector until the latches on either end
of the connector snap into place.
It may require some force to fully seat the card.
6
Make sure each latch fits over the notch on the end of the card.
Latch
Notch
Connection points
What do I do now?
Task Go to page…
Installing a firmware card 22
Installing a hard disk 23
Installing an option card 24
Replacing the system board access cover 25