IBM 12/24 GB DDS/3 4 mm, Руководство пользователя

Страница: 7 / 30

power cords for the computer and all attached devices; then open
the computer.
3. Before opening the static-protective bag containing the tape drive,
touch the bag to an unpainted metal surface on the computer for
at least two seconds. This will drain any accumulated static
electricity from the bag and your body. Remove the drive from
the static-protective bag. If you must put the drive down, place
the drive on the static-protective bag. Do not touch any exposed
components on the drive.
To install the drive, refer to the following drive backpanel
illustration.
.1/
SCSI connection
.2/
Jumper block
.3/
Power connection
4. Use the jumper block
.2/
to set your SCSI ID. The following
illustration shows the ON and OFF positions for the jumpers.
Jumper ON Jumper OFF
15
16
13
14
11
12
9
10
7
8
5
6
3
4
1
2
Pin 7 Omitted
.1/
SCSI ID area
.2/
Active Termination Enabled
.3/
Termination Power On
Area
.1/
is where you will set your SCSI ID. Refer to the
following table in order to determine the settings required:
1-2 12/24 GB DDS/3 4 mm Internal Tape Drive