MANUAL - THINPAR-7/9/12/14X6W-/36x1W-RGBW
3
www.ibiza-light.com
•
Make sure the power cord is never crimped or damaged.
•
Never disconnect the power cord by pulling or tugging on the cord.
•
Avoid direct eye exposure to the light source while it is on as sensitive persons may suffer an epileptic shock
(especially meant for epileptics)!.
•
The product is for decorative purposes only and not suitable as a household room illumination.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the manu
-
facturer or his service agent or a similar qualified person in order to avoid a hazard.
•
The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded..
DISCONNECT DEVICE
Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
FUSE REPLACEMENT
Locate and remove the unit’s power cord. Once the cord has been removed located the fuse holder located in
-
side the power socket. Insert a flat-head screw driver into the power socket and gently pry out the fuse holder.
Remove the bad fuse and replace with a new one.
Warning
: If after replacing the fuse you continue to blow fuses, STOP using the unit. Contact customer support
for further instructions. Continuing to use the unit may cause serious damage.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the
unit is secure and is able to support a weight of 10 times of the unit’s weight.
Never stand directly below the device when mounting, removing or servicing the fixture.
BUTTONS & CONNECTORS
No. Designation
No. Designation
1
Mounting Bracket
6
DMX Input (3-pole)
2
LEDs
7
DMX Output (3-pole)
3
Adjustment Screw
8
Power Input
4
Display
9
Power Output
5
Operating Buttons
LED DISPLAY
UP
DOWN
MENU
ENTER
8.8.8.8.
The LED display has 4 buttons: MENU / UP / DOWN / ENTER
MENU STRUCTURE
No.
Display
Function
1
D001
Setting the DMX address
2
8ch
4ch
Selection DMX Modes
4 or 8 Channel
3
Au01-Au08
Au09
Au10
So01
So02
Colour Jump
Colour Change
Gradient Colour Change
Sound Control Mode 1
Sound Control Mode 2
4
St00
St01-St16
No Function
Strobe Effect (Speed: slow to fast)