©
Copyright
Lotronic
2010
©
Copyright
Lotronic
2010
Installation
1. Firstly, be sure that the mains voltage matches the voltage marked on
the base of the laser lighting;
2. Installation should be made by professional technician. Fix the laser
lighting and adjust the angle of the laser lighting to your needs;
3. Please check whether the fan and the exhaust are blocked;
4. There is a hole for connection. When hang the laser lighting, be sure
the cable can undertake 10 times of the lighting weight;
5. The laser lighting should be fixed;
6. It is essential to be earthed well for the sake of safety.
DMX512
This laser light is controlled by the standard DMX. Please connect control
panel with the lighting as following
Before using the DMX512 controller, you should set the channel address.
It can be set 001 ~ 511 address. Every binary address switch has a digital
no. Please refer to:
No.
Digital No.
No.
Digital No.
1st 1
6th 32
2nd 2
7th 64
3rd 4
8th 128
4th 8
9th 256
5th 16 10th Function
switch
Maintenance
Please clean the lens regularly. Do not use the wet cloth or other
chemical. The frequency depends on the usage and surrounding
conditions; it is recommended that it should be cleaned every 20 days;
Please clean the lighting surface and engine outlet regularly.
Be sure that there is no flammable or explosive subject nearby. The least
distance is 0.5 meters.
Warning
Power off before installation or maintenance. The danger class of this
laser lighting is CLASS
3
B. it’s dangerous to look into the laser beam. The
safe minimum distance is 50cm, the safe maximum time is 10 seconds;
Keep at least 0.5 meters distance between the lighting and inflammable
material.
DMX Control Parameter Chart
Channel No
DMX512
fig.
Content
0-139 Black
out
140-209 Auto
play
Channel 1
Control
mode
210-255 manual
0-33 Static
pattern
Channel 2
Pattern
Selection
34-255
Dynamic Geometric
pattern
Channel 3
Strobe
0-255
8 grade speed
Channel 4
Spot and line
0-255
From line to spot effect
1~160 Manual
161~190
From left to right move
191-220
From right to left move
Channel 5
Horizontal
move
221-255
Right and left in-phase
move
1-160 Manual
161-190
From down to up
191-220
From up to down
Channel 6
Vertical
move
221-255
Up and down in-phase
move
Channel 7
Zoom(+/-)
pattern size
0-255
pattern size change
Channel 8
No special
Channel 9
Reset
0-255
The number come to more
than 200, the machine
reset
Channel
10
Gradually
paint
0-255 Gradually
paint
When the CH2 is selected the Static pattern mode (DMX value is 0--33),
you can use channel CH2, CH3-CH10 to control laser beam, otherwise
CH2, CH3-CH10 are invalid
