©Copyright LOTRONIC 2017
COMBI-FX1
Page 4
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
DMX address setting
Each fixture must have a specific starting address. When receiving signal transmission, every fixture will receive
channels control signals for its own starting address.
The user can set several fixtures to the same address or set up a separate address for every device.
If more than one fixture is set to the same address, all of them receive the same DMX channels signals. All connected
fixtures are jointly controlled; the controller can't control a device separately.
If every device is set to a different address, it will receive different DMX signals corresponding to its starting address.
This device has 22 channels, so the first device starting address is set 1, second is 23 (1+22), third is 45 (23+22) and
so on.
MENU operation
This fixture has 4 buttons on the rear panel to access, edit and set all functions.
[
MENU
]: press MENU key to enter into the submenus. Press MENU again to leave the sub-menu. If no key is pressed
during 30 seconds, the unit will go back to MENU display automatically.
[
Up
]: press UP key to increase the displayed values. Keep pressed to increase the values quickly.
[
Down
]
：
press DOWN key to decrease the displayed values. Keep pressed to decrease the values quickly.
[
ENTER
]
：
in normal status, this button has no function. In edit mode, press ENTER to enter into the sub-menu.
Function setting
1) DMX address setting
1. Press <MENU>
2. Press <UP/DOWN> to choose, then pres <ENTER> to enter [Addr]
3. Press <Up/Down> to choose address 001~XXX
4. Press <ENTER> to confirm, or press "MENU" to exit
2) Master-slave setting
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose [SLnd], press ENTER
3. Press <UP/DOWN> to choose Mast/SL1/SL2, etc.
4. Press <Enter> to confirm, or press "MENU" to exit.
3) Sound mode setting
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose [SoUn], press ENTER
3. Select So 0 ….. So4 for the different sound programs
Sound sensitivity Setting
(before this setting, press MENU, select <SoUn> and save. You must be in Sound Mode
first, before you can select the sensitivity)
1. Press MENU
2. Press UP/DOWN to choose [Sens], press ENTER
3. Press <Up/Down>, <Enter> to adjust the sound sensitivity from 99 to 0.
4. Press <Enter> to confirm, or press "MENU" to exit.
4) AUTO mode setting:
1. Press MENU.
2. Press UP/DOWN to choose [AUTO], press ENTER
3. Press<Up/Down> to select an automatic program from 0 to 4
4. Press enter to set the speed from SP0 to SP9
