Ibiza sound SLK8A-BT, Инструкция по эксплуатации, Страница: 4 / 30

©Copyright LOTRONIC 2013 Manual SLKA-BT series 4
Intermittent
Possible Cause Action
Bad connections A faulty speaker might of course work intermittently but it is much more likely that a
lead/connector is responsible. Check the insulation between the tip and the sleeve of
the plug. Check the solder of the connector, tighten the banana or Neutrik plug.
Ongoing noise
Possible Cause Action
Faulty electronic Any noise coming from the wiring of the amp, the mixer, the signal processor, the
Device in the signal source or a line level device. Check and correct the grounding.
Check if sources or electronic component cause the noise. Check the shielding.
Bad reproduction of the low frequencies
Possible Cause Action
Reversed polarity When 2 boxes placed next to each other are connected with a wrong polarity, they
cancel mutually their sound, especially in the low frequencies.
Check the speaker cables to make sure that they are all connected the same way.
Check the balanced signal cables to make sure that they are all wired properly.
Specifications
Frequency range ........................................................... 50Hz-20KHz
Sensitivity (1W/1m) ................................................................... 96dB
Dispersion angle ................................................................. 90° x 60°
Max power* ............................................................................. 300W
Power of the built -in amplifier............................................200W max.
Nom. impedance .................................................................. 8 Ohms
* Filtered noise according to IEC with a peak factor of 6 dB
** Calculation based on the peak power and the sensitivity.
Specifications of the built-in amplifier
Frequency range ............................................ 55Hz – 20kHz (+/-3dB)
RMS power ............................................................................ 100W
THD ............................................................................................ 1%
S/N ratio................................................................................... 80dB
Input sensitivity ...................................................................... 250mV