TCL SERIES
temperature controller
,%(67
嘐
%(67
Electrical & Automation
IBEST ELECTRICAL CO.,LTD
Digital Temperature ControllerUser Manual
TCL SERIES
P
2
www.ibestchina.com
0~50
ć
45~85RH%/86~106KPa
OPERATION CONDITION
POWER SUPPLY
DIMENSIONS
INSULATION STRENGTH
AC 1500V 1 min / DC500V
ı
50MΩ
AC 110V/220V ( * The dimenson 48W×48H is 85~260V AC )
4:48W×48H / 6:48W×96H/ 7:72W×72H/ 8:96W×48H/9:96W×96H
5.PANEL ILLUSTRATION
PV (Red LED)
ǂ
●
ǂ
display measuring value
ǂ
●
ǂ
display parameters
SV(Green LED)
ǂ
●
ǂ
display set value
ǂ
●
ǂ
display parameters value
AT lamp
green: auto-tune; flash: output
OUT lamp
green (on): control output;
Off: no output
ALM lamp
red(on) alarm output:
off: no alarm output
Increase key Decrease key
Function key
parameters set and confirm key
6.OPERATION ILLUSTRATION
Inp
K
80
180
999
000
Input
Input type: display the input type you ordered
Measuring value upper limit
Measuring value lower limit
Measuring value
Set point
Power on
A.Funcition adjustment
Enter into measuring status
Set temperature
Press“ ” key, the upper LED display “SP”; lower LED display set value , press “ ” or “ ” to modify the value you
need.Then confirm the value by press“ ” key again.
Control parameters
Press“ ”key for 5 seconds,the upper LED display the control parameters, the lower LED display the
parameters value.To modify the parameters value,please press “ ”and “ ” key. Press “ ” key to
confirm the value modified and then press “ ” to shift to the next parameter . If you want to escape the
control paraneters menu, please press “ ” key for 5 seconds; or no operation whithin 1 minutes also let
the lontroller go back to measuring estate. The parameters list ,please refer to page “T 3”
Auto-tune function
Press “ ” for 20 seconds ,“AT” Lamp flash, the instrument begins Auto-tune . when the unit goes through
1 or 2 temperature waves, “AT” lamp goes out, Auto-tune finishes. Please keep the parameter value for
future reference.
Notice
The red LED lower display “000”, it means the thermocouple wire was wrongly connected; If the red LED
upper display “000”, it means thermocouple open circuit or the temperature suppressed the measuring
scale.
