Version 1.0 08 JUL 1998
|||ibc 810 SMART CARD READER USER'S GUIDE
Page 4
ibc document PROG071
The 810 smart card reader reads memory-
style smart cards and can output the data
in wiegand/aba formats as well as stan-
dard serial.
This reader can be used as a direct plug
and play replacement for barcode, mag-
netic stripe, wiegand, or prox readers
which are connected to access control
controllers.
Features of the 810 readers are:
l
Bicolored led (controlled by the
controller or by serial commands)
l
Wiegand (26 bit) output (emulation
models).
l
ABA emulation output (emulation
models).
l
RS232 or RS422 connection
capability (serial models).
l
Optional onboard relay for door
actuation control (serial models
only).
l
Mountable to a standard gang box,
with integral face plate.
The 810 readers read standard memory-
style smart cards and output the data in
either wiegand/aba format or serially.
Emulation models output both wiegand
and aba on seperate lines.
Cards read by the 810 must be pro-
grammed using the proper format (see
Card Format section) iin order to be read
by the reader.
After a successful read, the reader will
output the data to the receiving system
(computer or controller), and then the
receiving system can trigger the led or
relay located in the 810.
FUNCTIONALITY
Mounting the reader is performed just like
mounting a wall plate, with two screws that
screw into a standard gang box.
The reader is normally mounted vertically
as shown in the picture above however it
can also be mounted horizontally.
MOUNTING
WIRING
The reader contains an 11-position screw
terminal connector for easy wiring, as
shown in the picture below.
Depending on your installation, not all of
the 11 terminals will be used. The follow-
ing table lists the use for each of the
terminals.
1
11
