IBC Water 500 series, Инструкция по установке и эксплуатации

Страница: 10 / 19

AS0715-E Page
10
Programming
General Information
The control valve is designed to initiate regeneration
according to pre-set factory parameters. Following
the instructions contained in this section will allow
the installer to customise the program for the users
exact needs.
The regeneration cycle is controlled by the time cam
located on the front of the timer assembly. The brine
& slow rinse cycle can be adjusted from 50 minutes
to 95 minutes in 5 minute increments. The backwash
and fast rinse cycles are not adjustable.
Factory Default Settings
The following default cycle settings are preset into
the control valve.
Cycles:
Backwash 11 1/2 minutes
Brine / Slow Rinse 70 minutes
Fast Rinse 4 1/2 minutes
Set Time of Regeneration
1. Remove the front dust cover from the timer
assembly.
2. Rotate the Time of Regeneration plate (A) until
the desired time appears in the window. Note
A.M. or P.M.
Set Time of Day
1. Remove the front dust cover from the timer
assembly.
2. Turn the Timer Knob (B) until the alignment
mark located on the Time of Day Gear (C)
points directly to the correct time of day. Note
A.M. or P.M.
Set Regeneration Frequency
1. Remove the front dust cover from the timer
assembly.
2. Pull all skipper wheel tabs up.
3. Rotate skipper wheel (D) until the number one
tab aligns with the DAY mark (E)
4. Starting with the number one tab, push down the
tabs to determine the days on which
regeneration is required.
Regeneration Cycles
The backwash and fast rinse cycles are non-
adjustable. Adjusting the brine and slow rinse cycle
can be accessed according to the following
procedure:
1. Loosen the screw located on top of the timer
cover, remove front dust cover from timer
assembly.
2. Turn Timer Knob (B) until setscrew on the time
cam is visible.
3. Loosen setscrew, and using the alignment mark
(F) located on the lower cam, move timing cam
to the desired length of time.
4. Tighten setscrew and install dust cover.