INSTALLATIONS
10
IB100 User’s Manual
Setting the Jumpers
Jumpers are used on IB100 to select various settings and features
according to your needs and applications. Contact your supplier if you
have doubts about the best configuration for your needs. The following
lists the connectors on IB100 and their respective functions.
Jumper Locations on IB100 ................................................................. 11
Jumper Locations on IB100 ................................................................. 11
J13: COM1 RS232 (RJ45) PIN8 /+5V/+3V Power Setting................ 13
J13: COM1 RS232 (RJ45) PIN3 /+5V/+3V Power Setting................ 13
J14: CN6 ID Pin Control (factory use only) ........................................ 14
S1 (sw1,sw2,sw3,sw4,sw5,sw6): System Boot Configuration
S1 (sw8): DVI Signal Output Control ................................................. 15
D8,D9,D10,D11,D12,D13,D14,D15,D16,D17,D18,D19: ................... 15
Содержание IB100
