iB HERMES 306, Инструкция по монтажу

Страница: 3 / 12

EN
TECHNICAL DATA
Minimum dynamic pressure:_______________________________________________________________0.5 bar
Maximum operational pressure:______________________________________________________________5 bar
Recommended operational pressure:_______________________________________________________1-5 bar
It’s recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature:____________________________________________________________80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fine in time, must ensure compliance with the mode
of installation and maintenance described in this booklet. Relying on a qualified plumber. Make sure
that the system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Fix the body to the fixing plate.
Fig. 2-3: Make a hole into the wall with a minimum measure of 100 mm - 3.93 in, 210 mm – 8.26 in,
and MIN 72 mm - 2.83 in, MAX 82 mm - 3.22 in depth.
N.B.: The minimum and maximum measure have to be considered in relation to the finished wall,
cladding included.
Fig. 4-5: Fix the recessed body taking in consideration the perpendicularity, both vertical and hori-
zontal, by using a spirit level.
Fig. 6: Connect the body to the hydric system. It’s recommended to use hemp or PTEF for granting
the endurance.
Fig. 7: Screw the spout to the hemp or PTFE body to ensure the seal.
After connecting the body to the system, turn on the stopcocks and check that the mixer tap unit
operates correctly. Keep the tap pressurised for a few minutes checking eventual leaks.
Fig.8: Screw the reductions on the headworks.
Fig. 9: Reduce the hole in the wall, leaving two diameters MIN Ø30mm - 1.18 in, MAX Ø40 mm - 1.57
in for the headwork and MIN Ø35 mm - 1.37 in, MAX Ø40 mm - 1.57 in for the spout.
Fig. 10: Screw the bell on the reductions against the wall, insert the handle on the broach, locking
it with the screw. Screw the finishing plate. Repeat the operation for the second handle. Slide the
rosette of the spout against the wall.
CLEANING
In order to obtain a correct cleanliness, exclusively wash them with soap and water, rewash and dry
them with a soft towel and deerskin. Avoid the usage of alcohol, solvents, solid or liquid detergents
which contain corrosive or acidic substances, abrasive sponges, swab with metallic strings because
they could irreversibly compromise the surfaces.
THE USAGE OF THIS KIND OF DETERGNETS DURING THE CLEANING OF THE MIXER EXCLUDE IB
RUBINETTERIE FROM ANY WARRANTY OBLIGATION.