3
iArmor
®
Customer Support: [email protected]
Rev. 20200801
STEP 3
(Fig 2) Insert M8 Bolt/Nut Plate (NOTE: M8 Bolt/Nut Plate is not
required on models with threaded inserts)
Determine the correct procedure to attach (1) Driver Front
Mounting Bracket (
DFM/DCM/DRM
) for your model/year:
Models without factory threaded inserts in body panel:
a.
Select (1) M8 Bolt/Nut Plate
(Fig 2)
. Use the welded bolt as
a handle, insert the welded nut end through the oval factory
hole, and line up the welded nut with the hex hole. Thread (1)
M8 Plastic Washer onto the threaded end and down tight
against the body panel,
(Fig 2)
.
NOTE
:
The Plastic washer is
designed to keep the Bolt-Nut Plate from falling into the
body panel and to aid in bracket installation.
b.
Attach (1) Driver Front Mounting Bracket (
DFM/DCM/DRM
)
to the welded nut end of the M8 Bolt/Nut Plate on the driver
side front location with (1) M8 Flat Washer, (1) M8 Lock Wash-
er and (1) M8X1.25
–
30Hex Bolt, (
Fig 3
). Do not fully tighten at
this time.
Models with factory threaded inserts:
Attach Driver Front Mounting Bracket to the threaded inserts
with (1) M8x1.25-30 Hex Bolt, (1) M8 Lock Washer and (1) M8
Flat Washer
(Fig 4 &5)
. Leave hardware loose.
(Fig 3) Attach Driver Front Mounting Bracket to M8 Bolt/Nut
Plate
M8 Bolt/Nut Plate
M8 Plastic Washer
(1) M8 Flat Washer
(1) M8 Lock Washer
(1) M8X1.25-30 Hex Bolt
M8 Bolt/Nut Plate
DFM
Front
Front
(Fig 4) Driver Side Front Mounting Location mid 2015
—
on, (an
example of models with factory installed threaded inserts)
(1) M8X1.25-30 Hex Bolt
(1) M8 Lock Washer
(1) M8 Flat Washer
(Fig 5) Driver Front Mounting Bracket installed for models w/
factory threaded inserts(M8 Bolt/Nut Plate not required)
Fron
t
