Rev. 20211001
4
iArmor
®
Customer Support: [email protected]
(Fig 2) Insert M8 Bolt/Nut Plate (NOTE: M8 Bolt/Nut Plate is not
required on models with threaded inserts)
M8 Bolt/Nut Plate
M8 Plastic Washer
(Fig 3) Attach Driver Front Mounting Bracket to M8
Bolt/Nut Plate
M8 Bolt/Nut Plate
Front
Front
(Fig 4) Driver Side Front Mounting Location
(example of models with factory installed threaded inserts)
(Fig 5) Driver Front Mounting Bracket installed for models w/
factory threaded inserts (M8 Bolt/Nut Plate not required)
Fron
t
STEP 4
Attach the Driver Front Support Bracket to the Driver Front
Mounting Bracket with (1)M8x1.25-30 Hex Bolt, (2) M8 Flat
Washers and (1) M8X1.25 Nylon Lock Nut,
(Fig 6)
.
Rotate and attach the support bracket to the back of the pinch
weld. Line up the slots in the top of the Support Bracket with
the (2) factory holes on the pinch weld. Secure the Bracket to
the back of the pinch weld with (2) M6x1-25 Hex Bolts, (4) M6
Flat Washers and (2) M6X1 Nylon Lock Nuts,
(Fig 7)
. Do not
fully tighten hardware at this time.
IMPORTANT
:
Some models are not equipped with factory
holes and will require drilling through the pinch weld to
attach the Support Bracket. Do not drill through pinch weld
at this time, (Refer to Step 8).
(1) M8X1.25-30 Hex Bolt
(1) M8 Lock Washer
(1) M8 Flat Washer
(1) M8 Flat Washer
(1) M8 Lock Washer
(1) M8X1.25-30 Hex Bolt
