Rev. 20220502
iArmor
®
Customer Support: [email protected]
3
The instruction here is for your reference only. We strongly
recommend the professional installer for best result. We are
not responsible for any damage caused by the installation.
STEP 1
Start the installation under the driver side of the vehicle. Locate
the 6 plugs along the bottom edge of the body panel. Mounting
Brackets will bolt to the 1st, 3rd, 4th and 6th threaded mounting
holes,
(Fig 1).
(Fig 1) Driver side Rocker Panel mounting locations
(For Some Models)
Front
STEP 2
Remove the plastic plugs from each mounting location if
equipped. Hold up a Mounting Bracket in place to determine
the mounting holes on the body panel,
(Figs 2 & 3).
(Fig 2)
Remove Plastic Plugs to Uncover Threaded Inserts
Front
Remove plugs if equipped
STEP 3
Select the Driver Front Mounting Bracket
(DFM)
. Attach the
Bracket to the factory threaded holes with (2) M8X1.25-30 Hex
Bolts, (2) M8 Lock Washers and (2) M8 Large Flat Washers,
(Figs 4 & 5)
. Do not fully tighten hardware at this time.
(Fig 3)
Driver Side Front Mounting Location
Front
(2) M8X1.25-30 Hex Bolts
(2) M8 Lock Washers
(2) M8 Large Flat Washers
(Fig 4)
Driver Front Mounting Bracket Installation
