4
Rev. 20220601
iArmor
®
Customer Support: [email protected]
(Fig 4) Driver Front Bracket Assembly
(1) M12X1.75-35 Hex Bolt
(1) M12 Lock Washer
(2) M12 Large Flat Washers
(1) M12 Hex Nut
STEP 3
Move to the Driver Side Rear Mounting Location, repeat
Steps
1 & 2
for the Rear Brackets installation.
(Fig 5).
(Fig 5) Driver Rear Bracket Assembly
(1) M12X1.75-35 Hex Bolt
(1) M12 Lock Washer
(2) M12 Large Flat Washers
(1) M12 Hex Nut
STEP 4
Once all (2) Brackets have been installed, attach the Driver
Side Bar to the assembled Bar Brackets with (4) M10X1.5-25
Hex Bolts, (8) M10 Flat Washers and (4) M10X1.5 Nylon Lock
Nuts,
(Fig 6)
. Do not fully tighten hardware at this time.
Properly level and adjust the Step Bar and fully tighten all hard-
ware.
STEP 5
Move to the other side of the vehicle. Repeat
Steps 1-4
for the
other side step bar installation.
Attention
Do periodic inspections to the installation to make sure
that all hardware is secure and tight.
In order to protect your bars/boards, please use mild
soap/non-abrasive products for cleaning only.
DFB
DRB
Mounting Bracket
Mounting Bracket
