Rev. 20211001
4
iArmor
®
Customer Support: [email protected]
STEP 5
Repeat
Step 4
to install the Driver center Mounting Bracket and
Driver Rear Mounting Bracket
,
(Fig 4)
.
(Fig 4) Driver Center/ Rear Mounting Bracket Installed
Front
(3) M8 Flat Washers
(3) M8X1.25 Nylon Lock Nuts
STEP 6
STEP 7
Once all (3) Brackets have been installed, attach the Assem-
bled Driver Side Step Bar to the Mounting Brackets with (6)
M6X1-20mm T-Bolts, (6) M6 Large Flat Washers & (6) M6X1
Nylon Lock Nuts,
(Fig 5)
. Do not fully tighten hardware at this
time.
Properly level and adjust the Step Bar and fully tighten all hard-
ware.
STEP 8
Move to the other side of the vehicle. Repeat
Steps 1
—
7
for
other side Step Bar installation.
Attention
Do periodic inspections to the installation to make sure
that all hardware is secure and tight.
In order to protect your bars/boards, please use only mild
soap/non-abrasive products for cleaning.
(Fig 5) Assembled Driver Side Step Bar Installed
Warning: Install the T-bolt on the step
bar and rotate it to 90 degrees!!!
(4) M6X1-20mm T-Bolts
(4) M6 Large Flat Washers
(4) M6X1 Nylon Lock Nuts
Front
(2) M6X1-20mm T-Bolts
(2) M6 Large Flat Washers
(2) M6X1 Nylon Lock Nuts
