- 27 -
Remote control malfunctions
1.
Replace the remote control batteries.
2.
Clean the upper edge of the remote control (transmission window).
3.
Check the battery terminals.
There is a message on the screen
1. If it reads "
Check signal cable
" on the screen, check if the signal cable is connected to the PC or video
sources. (15 pin D-Type Connector) and check if the PC or video sources are turned on.
2. If it reads "
Unrecognised monitor, plug and play (VESA DDC) monitor found
" on the screen then check
for your newly installed devices. See the video card manual to see if the plug and play (VESA DDC)
function can be supported. Find the updated monitor driver from our site and install the monitor driver
according to the driver installation instructions.
Note:
If a problem repeatedly occurs, contact an authorized
iameco
™
service centre.