iAIRE
ION Kit I/O/M
iAIRE, LLC
9
READ THESE INSTRUCTIONS BEFORE
B
EGIN
NING
INSTALLATION
INSTALLATION
ION-0A*00 INSTALL
Ion Generator for AHUs, Heating and AC Units
(Be sure to follow all local and electrical codes. Turn off power to the
unit before mounting or making any connections.)
• Verify the product will not overload the power requirement for
the HVAC system before wiring.
• Check the label on the product and wire it only to the voltage
range shown. The 24V product accepts VAC/VDC power and
can be utilized as a
lower voltage
block with
less
output.
• Unit should be
interlocked to fan operation (
"
G
"
terminal) or
other similar
control.
• Inline C-Class Fusing:
500mA @ 24V; (FUS-0037)
2
00mA @ 115V/208V/230V (FUS-004
8
)
• Green LED will illuminate when powered and operating.
fig. 1.3 (optional mounting bracket)
35 inch black = Neutral
or Ground (HVAC “C”
Terminal) or chassis in
case of furnace
35 inch red = Positive
(HVAC "G" Terminal)
Mounting holes for ion air purifier
Mounting holes for bracket
VOLTAGE:
A - 24VAC / VDC, 1ϕ
D - 115VAC, 1ϕ
G - 208/230VAC, 1ϕ
I O N - 0A * 00
PN: UNV0016 (not included)
Find a suitable location in the air stream. The optimal location is at the inlet to the supply fan.
Keep the carbon fiber needles far enough away from any conductive surface to prevent arcing.
The ion air purifier has two mounting flanges with a hole to accommodate 1/8" self tapping sheet metal
screws [ figure 1.1 ]. With the provided metal screws, mount the ion air purifier perpendicular to and in
the middle of the air stream such that air will flow between the carbon fiber needles [figure 1.2]. The
exposed end of the screw should not
protrude from the unit where someone
fig. 1.
1
(mounting)
fig. 1.
2
(
airflow
)
can be cut on the screw tip.
Top
MAINTENANCE
In some cases, to properly mount the ion
air purifier, the optional mounting bracket
(not included) is required [ figure 1.3 ].
This bracket has (4) holes: (2) that
accommodate mounting of the ion air
purifier and (2) for mounting with #10 hardware to a surface so the air
purifier is perpendicular to the air stream.
A small cleaning brush (GNP-0148) is included for easy, routine
maintenance. This should be done as the ion brushes become dirty,
usually once a month
.
Inline C-Class Fuse
UL STD 867
CAN/CSA
STD C22.2
File# 101141865COL-003
The
iAIRE
ion generator is a versatile product and can be mounted in any type HVAC system. It is
designed for airflows of up to 2,
5
00 CFM and standard VOC loading. 1
250
CFM in smoking environments.
MOUNTING
iAIRE, LLC | 2100 Consulate Drive, Suite 102, Orlando, FL 32837
www.myultrapure.com | Toll Free 844-348-9168
IOM-0017
PD
0
4
/
20
/20
2
3
- v 1.5
5
Note:
If vibration of block occurs, 1/2" double sided foam tape (GNP-0176) can be used
.
