IAI RCP6S, Инструкция по эксплуатации

Страница: 94 / 147

89
3.
C
onn
ec
tin
g w
ith
the C
ont
ro
ller
Warning: For wiring, please follow the warnings stated below. When constructing a system as the
machinery equipment, pay attention to the wiring and connection of each cable so they
are conducted properly. Not following them may cause not only a malfunction such as
cable breakage or connection failure, or an operation error, but also electric shock or
electric leakage, or may even cause a fire.
•
Use dedicated cables of IAI indicated in this instruction manual. Contact us if you wish to have a
change to the specifications of the dedicated cables.
•
Make sure to turn the power off in the process of power line or cable connection or
disconnection.
•
Do not attempt to cut a dedicated cable with connectors on both ends to extend, shorten or
re-joint it.
•
Hold the dedicated cable to avoid mechanical force being applied to the terminals and
connectors.
•
Use a cable pipe or duct to have an appropriate protection when there is a possibility of
mechanical damage on a dedicated cable.
•
In case a dedicated cable is to be used at a moving part, make sure to lay out the cable without
applying any force to pull the connector or extreme bend on the cable. Do not attempt to use the
cable with a bending radius below the allowable value.
•
Make certain that the connectors are plugged properly. Insufficient connection may cause an
operation error, thus it is extremely risky.
•
Do not lay out the cables to where the machine runs over them.
•
Pay attention to the cable layout so it would not hit peripherals during an operation. In case it
does, have an appropriate protection such as a cable track.
•
When a cable is used hanging on the ceiling, prevent an environment that the cable swings with
acceleration or wind velocity.
•
Make sure there is not too much friction inside the cable storage equipment.
•
Do not apply radiated heat to power line or cables.
•
Do not bend the cable in the area from the connector tip inward to 150mm on both ends.
Motor • Encoder Integrated Cables CB-CAN-
MPA□□□, CB-CFA3-MPA□□□
Motor • Encoder Integrated Cables Robot Type CB-CAN-
MPA□□□-RB
、
CB-CFA3-
MPA□□□-RB