Installation & Operation Manual for 600mm Multifunction ovens
New picture with frame outside
L1: Operation period
L2: Operation end
L3: Minute minder
L4: Adjust time-of-day
Depending on the variant in hand either the 4 LEDs at the side of the display or the 4 LEDs
below are active for displaying the mode.
Time of day
When connected to mains supply the display shows 12.00 o’clock and the LED L4 flashes. As long
as it is flashing, it is possible to adjust the time via the plus and minus buttons.
Once the time is adjusted, it is stored approx. 5 seconds after the last operation, the LED L4 goes
dark again.
It is possible to adjust the time-of-day by pressing the mode button until L4 flashes, then the
time-of-day can be adjusted.
Minute minder (interval time)
In order to set the interval time, the “Mode” button has to be pressed repeatedly until LED L3 is
flashing. Then the interval time can be set between 0.01 and 2.30 h by using the plus and minus
buttons. After setting the interval time, it remains displayed and the LED L3 is now illuminated
steadily. After th interval time has run down, the alarm signal sounds (2 beeps every 2 seconds)
and the LED L3 is flashing again. Pressing any of the buttons stops the signal and the flashing, the
LED goes dark and the display reverts to the time-of-day. If the alarm is not stopped manually, it
terminates automatically after 2 minutes.
The minute minder can be applied at any time while other functions are operative.
Operation period
In order to set an operation period, the mode button has to be pressed repeatedly until the LED L1
is flashing. Then the desired operation period (time frame between 0.01h and 10.00h) can be set
using the plus and minus buttons. Once adjusted, it will be stored after approx.. 5 seconds, the LED
L1 remains illuminated steadily, and the set time starts running down. The display reverts to the
time-of-day. As soon as the operation period has ended, the relay opens and the alarm signal
sounds (4 beeps every 2 seconds) and the LED L1 is flashing again. Pressing any of the buttons
stops the signal and the flashing, the LED goes dark and the relay closes again. If the alarm is not
