11
Adjusting Worksurface Support Assemblies
PLEASE NOTE:
It is very important that you read through and understand all the instructions
below before making any adjustments to the worksurface support assemblies. If you need
assistance please contact IAC Industries customer service at 800-989-1422.
STEP 1:
Lower the motorized system to its lowest point. Remove the inner cylinder cover from
the worksurface support assembly that you are adjusting. Loosen the
five nuts “A” at the rear
edge of the worksurface support bracket
as shown below with a 7/16” wrench. Loosen only 1/4 of
a turn. DO NOT over loosen or remove these nuts.
STEP 2:
Locate the three guide adjustment set screws
“B” found at the back of the worksurface
support assembly as shown. Us
ing a 3/32” Allen wrench turn the set screw clockwise gently to
tighten the two (2) set screws found at the top and middle of the worksurface support assembly.
DO NOT over tighten. Raise the motorized system the minimum amount required to expose the
lowest set screw. Gently tighten this set screw. DO NOT OVER TIGHTEN THE SET SCREWS.
STEP3:
When all three (3) set screws have been adjusted retighten the five nuts that were
lessened in Step 1. NOTE: these nuts are lock type so they do not need to be over tightened,
however it is important that they are tightened enough to hold the guild runner in place.
STEP 4:
After making adjustments to the worksurface support assemblies that require it run the
motor system up and down through its entire adjustment range to make sure it moves freely and
does not bind. If it does not move freely the adjustments made are too tight. Lower the system to
its lowest point and readjust the set screw following the steps above. Once satisfied that the
system is adjusted correctly reattach the inner cover and return to page 7.