14
www.i3-learning.com
14
www.i3-learning.com
Contact the
nearest service
center if the
projector
displays these
symptoms.
Warning Indicator
When the warning indicators (see below) come on,
the projector will automatically shutdown:
“LAMP” LED indicator lights in solid Red.
“TEMP” LED flash light in Red, this indicates the projector
has overheated. Under normal conditions, the projector
can be switched back on.
Unplug the power cord from the projector, wait for 30 sec-
onds and try again. If the warning indicator light up again,
please contact your nearest service center for assistance.
Powering Off the Projector
1. Press the “ ” button on the remote control or
on the control panel to turn off the projector.
The following message will be displayed on the screen.
Press the “ ” button again to confirm otherwise the
message will disappear after 15 seconds. When you
press the “ ” button for the second time, the fan will
start cooling the system and will shut down.
2. The cooling fans continue to operate for about 35 sec-
onds for cooling cycle and the POWER/STANDBY LED will
Flash Blue. When the POWER/STANDBY LED lights solid
Red, the projector has entered standby mode.
If you wish to turn the projector back on, you must wait
until the projector has completed the cooling cycle and
has entered standby mode. Once in standby mode, sim-
ply press “ ” button to restart the projector.
3. Disconnect the power cord from the electrical outlet and
the projector.
4. Do not turn on the projector immediately following a
power off procedure.
