INSTALLATION
• ON: enable the BLC function.
• OFF: disable the BLC function.
- Brightness: adjust the image brightness level, to “Low”,
“Middle” or “High”. The default is “Middle”.
- Contrast: adjust the image contrast level, to “Low”,
“Middle” or “High”. The default is “Middle”.
- Saturation: adjust the image saturation level, to “Low”,
“Middle” or “High”. The default is “Middle”.
- Sharpness: adjust the image sharpness level, to “Low”,
“Middle” or “High”. The default is “Middle”.
Communication:
Click “Communication” to view the current network settings, including
“Network”, and “NTP”. Configure all Network, and NTP settings in the
Network section.
1. DHCP: the IP address is automatically obtained when this is
checked; otherwise, uncheck it to set up the network settings
manually. If you enable the DHCP function, just specify DNS and
HTTP Ports in the below fields.
2. IP Address: specify your IP address here if you don’t select DHCP.
3. Subnet Mask: use default number: 255.255.255.0.
4. Default Gateway: leave blank as default setting. It is not required
if it is not used. Please contact your Network Administrator for
Default Gateway information.
24
