9
Rev.
130130
i3-TRNG-CAMS-
Di721/Do721
.indd
3.5.1 Surface mount
1. Attach the Guide Pattern Sticker to the wall or ceiling.
2. Drill two holes on the mounting surface and insert the plastic anchors (#1) into
the holes.
3. Do-series only: Complete drilling 2 holes on the base of the camera to match the
2 holes drilled on the mounting surface.
(Recommendation: Surface conduit should point down to create a drip-loop.)
4. Do-series only: Remove the protective film from the black rubber gasket and
adhere to the base of the outdoor model cameras.
5. Secure the bottom case to the wall or ceiling with the Flat Head Screws
(tapping type) (#2).
For your convenience, the holes on the outdoor housing are started but not
drilled all the way through for moisture control.
Note: Depending on the material of your mounting surface, you may require
different screws and anchors than those supplied.
1. Plastic Anchors
2. Flat Head Screws
(Tapping Type)
Note: outdoor
screws come with
O-rings included.
Note: The Do-series
cameras come with a
large rubber gasket to
provide the seal between
the mounting surface and
the camera base.
Figure 3.4 Camera Surface Mounting
