IACER Srl
26
MNPG117-02
Device care
Maintenance
If used following the instructions given in this user guide, the equipment does
not require any particular kind of maintenance.
It is recommended that the manufacturer carries out a functional test every 24
months. The manufacturer does not consider the I-TECH UT2 device repairable
by any personnel outside the company. Each operation of the kind perpetuated
by personnel not authorized by the manufacturer will be considered as
tampering the device, freeing the manufacturer from granting warranty and
from any danger that the user or the operator may be exposed to.
CLEANLINESS
Switch off I-TECH UT2 after each therapy session, as well as remove the cable
by the specific connector.
Clean the device from dust using a dry soft cloth. Resistant strains can be
removed using a sponge soaked in solution of water well squeezed.
ATTENTION! No alcohol content solution
. If a more sterile cleaning is needed,
use a cloth moistened with an antimicrobial cleaner.
Device not subject to sterilization.
Note:
−
Never use solvents for cleaning. Cleaning agents cause damage to the
device.
−
Attention to the need for periodic maintenance, especially:
•
inspection of main body for cracks, which may allow the ingress
of conductive fluid;
•
inspection of the main cable.
Clean the ultrasound head to remove gel AFTER EACH USE using a soft cloth or
paper cloth, lightly wet if needed. Aggressive clearing agents could damage the
rubber insulation and shorten the life of the cables.
After cleaning the external box, dry all of the parts carefully before turning on
the device.
Do not disassemble the device to clean or check it: there is no need to clean
the inside of the machine and in any case this operation should be performed
by skilled technical personnel authorized by I.A.C.E.R. Srl.
TRANSPORTATION AND STORAGE
Precaution for the transportation
