To use your Clip ME 304 Bluetooth headset (“headset”), please follow the steps
below:
1. Ensure your headset is fully charged.
2. Pair your charged headset with a Bluetooth-enabled mobile phone.
Getting Started
Charging Your Headset
Indicator Light
Charging
Fully charged
Low battery
Out of battery
Out of Range
♦
Charging indication will be delayed for a few seconds if the headset has
not been used for a long time or the battery is drained.
♦
3 hours are required to fully charge the headset.
Talk and Standby Time
A fully charged battery can offer up to 4.5 hours of talk time and up to 90 hours
of standby time. The headset remains in standby mode after being turned on.
Long Green
The light turns off
Double flash Green
The light turns off
Flash 4 Green every 15 sec until headset
reconnect and timeout after 10 mins
Charging socket
Charger’s plug
Use only the supplied charger / USB charging cable to charge the headset.
Fig.2
The headset comes with a built-in
rechargeable battery. Prior to using the
headset for the first time, it is recommended
to fully charge the battery.
Insert the charger’s plug into the headset’s
charging socket (see fig.2) and plug the mains
charger to an AC wall outlet or plug to the
PC/notebook.
Headset Status
Status Indicator Light (fig.1)
6
7
1) Ensure the headset is off.
2) To activate the pairing mode, press and hold the headset’s MFB without
releasing your finger until its status indicator blinks green.
3) Activate your mobile phone’s Bluetooth, search Bluetooth devices, select
“Clip ME 304” and enter the passcode “0000”. When the pairing is
completed, the headset’s status indicator will flash green light rapidly five
times.
If the pairing cannot be completed within 3 minutes after the pairing mode
has been activated, the headset’s status indicator will stay green 3 seconds
and then turns to standby mode. Repeat steps 1 to 3 to pair the devices again.
Pairing Your Headset with a Bluetooth Mobile Phone
Using Your Headset
Function
Button
Audio
Status indictor
POWER ON
Press and hold the
MFB for 2 seconds
Press and hold the MFB
Press the MFB once
Press the MFB once
Press the Volume Key
once to increase /
decrease by 1 step (Total
6 levels)
POWER OFF
Incoming call
Answer a call
End a call
Adjust Volume
When you turn on your headset for the first time, the headset proceeds into pairing mode, i.e.
the status indicator blinks green, so that you can immediately pair it with your mobile phone.
a short beep
a long beep
Flash green light 3 times
Green light for two seconds
and then the light goes off
Quick flashing green light
Flashing green light
Flashing green light
Flashing green light
Ringtone on earphone
and Short buzzers
9
8
