4. Advanced Setup
This section is in detail for how to assign IP address for CCE900-
IP-T and CCE900-IP-R, and how to upgrade firmware.
4.1 Setup IP address
A HTTP server is embedded in CCE900-IP-T and CCE900-IP-R for
changing IP and firmware upgrade. However, the changing IP and
firmware upgrade is available in
Setup Mode
only, not in
Normal
Mode
.
For the CCE900-IP-R, there are 2 internal IP: the operation IP
and configuration IP. The operation IP is changeable but the
configuration IP is always fixed at 192.168.168.22.
For the CCE900-IP-T, the operation IP is same as configuration IP.
The factory default IP is shown on the label under the box. That
means, you should remember the final IP, otherwise, you will not
be able to configure the CCE900-IP-T. In case of missing the final
IP, you should use a special software tool to find IP out.
Please follow below steps to configure the IP settings:
Step 1:
For CCE900-IP-R, assign your PC IP address in between
192.168.168.1 and 192.168.168.254, excluding
192.168.168.22, and the subnet mask with 255.255.255.0.
For CCE900-IP-T, the factory default IP is shown on the
label that stuck on the bottom of the CCE900-IP-T. The PC
IP address need to be on the same network as CCE900-IP-
T. For example, if the CCE900-IP-T IP is 10.100.1.10, you
might set your PC IP address as 10.100.1.1 and the subnet
mask as 255.0.0.0.
Step 2:
Unplug the power plug, hold the
[Reset]
button of the
device.
Step 3:
Keep holding the
[Reset]
button and plug the power on.
Step 4:
Release the [Reset] button when you see the
[Status]
(or
[Power]
) LED starts blinking red.
12
