i-team i-mop XL Pro, Руководство пользователя

Страница: 37 / 46

37
7.2 Squeegee replacement
The squeegee blades come in pairs and wear out over time. When you notice the floor is no
longer being dried properly, replace the squeegee blades.
7.2.1 Detaching the squeegee
1. Put the i-mop
®
XL Pro in store position,
see section 4.2.
2. Hold the scrub deck firmly with one hand.
3. Pull on the left side of the squeegee to
remove it (Figure 32, pos. 1).
4. Pull on the right side of the squeegee to
remove it (Figure 32, pos. 2).
5. Remove the vacuum hose from the
squeegee by twisting the hose.
Figure 32
7.2.2 Flipping/replacing the squeegee blade
1. Unscrew the 8 plastic nuts on the back.
2. Take off the squeegee rear plate.
3. Once the plastic part is removed, you can easily take off the rear rubber blade.
4. Push the 8 screws through the front blade in order to remove the squeegee front plate.
5. Take off the rear rubber blade.
6. Inspect the front and rear rubber blades:
•
The first time: flip the blades so the top of the blade is now facing the floor. Push the front
plate screws through the holes.
• The second time: attach a new set of blades. Push the front plate screws through the holes.
CAUTION
The special squeegee blades that contain small arrow-like shapes cannot be
switched. These need to be replaced every time.
7.
Put back the plastic rear plate.
8. Screw the 8 plastic nuts on the back.