38
7.2
Checking the machine operating hours
ATTENTION
This maintenance task should only be done by a supervisor.
1.
Take place on the seat behind the steering
wheel.
1.
Place the ignition key in the keyhole
(Figure 30, pos 1).
2.
Turn the ignition key to position "l". The
dashboard on the steering wheel lights up.
3.
Wait until "Ready" (Figure 31, pos 2)
appears on the display.
4.
The amount of operating hours and minutes
spent is shown in the top right corner of the
display (Figure 31, pos 1).
5.
Check the maintenance frequency table in
section 7.13 to see which actions should be
taken.
6.
Turn the ignition key to "0" to switch off the
i-drive®.
Figure 30
Figure 31
