Version 0.3
Page | 7
Using the Charger
Each handset is charged through the use of a handset charger. The charger is a compact desktop unit
designed to charge and automatically maintains the correct battery charge levels and voltage. The
charger Handset is powered by AC supply from 110-240VAC that supplies 5.5VDC at 600mA. When
charging the battery for the first time, it is necessary to leave the handset in the charger for at least 10
hours before the battery is fully charged and the handset ready for use.
Handset in the Charger
For correct charging, ensure that the room temperature is between 0°C and 25°C/32°F and 77°F. Do
not place the handset in direct sunlight. The battery has a built-in heat sensor which will stop charging
if the battery temperature is too high.
If the handset is turned off when placed in charger, the handset turns on and shows (shortly) the
charging message “The battery is charging”. After a while the display backlight first dim and then turns
off (if not demo mode is enabled). There will be response for e.g. incoming calls. If the handset is
turned on when placed in charger, the display shows (shortly) the charging message “The battery is
charging”. After a while the display backlight first dim and then turns off.
Open Back Cover
1.
Press down the back cover lock and lift back cover away from the handset.
2.
Remove Back Cover from Handset
Handset Serial Number
The serial number (IPEI/IPUI number) of each handset is found either on a label, which is placed
behind the battery, or on the packaging label. First, lift off handset back cover and lift the battery and
read the serial number.
The serial number is usually needed to enable service to the handset. It must be programmed into the
system database via the SME VoIP Configuration interface.
