8
①
INITIAL SET button (Initializing)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera.
When using a PoE hub, disconnect the Ethernet cable from the camera. When using an external
power supply, disconnect the power cord plug (accessory) from the power supply terminal (12V
DC).
⑵
T urn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds.
In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
Parts and functions
■
Indicator and button
①INITIAL SET button
②LINK indicator
③ACT indicator
