I+ME ACTIA I+ME ACTIA NetPorty II, Руководство пользователя

Страница: 23 / 50

Installation
Installing the Software
Version 1.03
2-5
Problems :
It is possible you chose an incorrect COM port. Start
PcCANControl again and choose an other COM port.
2.3.2 If you start at parallel port
1 Make sure that your PC parallel port uses the EPP-
mode . You have to control it under BIOS setup. In
this version the NetPorty II supported the EPP
versions 1.7 and 1.9. If necessary configure your PC
and re-start it.
2 Follow steps 1-5 under chapter 2.3.1.
3 Configure the right driver . Change to directory
“.. / I+ME ACTIA / CANctrl-PTY / ParDrv95
(.. / ParDrvNT) and start the batch-file
Drvinst.bat
4 At this point you have to reboot your PC to start the
right driver.
5 Install PcCANControl, follow steps 1-5 under chapter
2.3.1 Application installation.
Problems : (see also chapter troubleshootings)
You start PcCANControl but the connection doesn’t
work:
For parallel port usage it is necessary to have the EPP-
loader-firmware (BOOTLOAD.H86) in the
NetPorty II -
Flash-EPROM.
All Porty's are delivered with this loader but it is possible
that you have overwritten it by your own firmware.
In this case it is possible to download the EPP-firmware
again into the
NetPorty II -Flash.