® Waves System
V 1.3 - 2018
I.D. AL - MicroPlayer mkIII - Wav MP3 Audio player - User manual
- 11 -
001 [J100]: After reading folder 001, jumps to folder 100
002 [J100]: After reading folder 002, jumps to folder 100
100 [RET]:After reading folder 100, returns to the previous folder (001 or 002)
In the above example, after reading folders 001, 002, a jump to folder 100 is made to read the content.
After reading folder 100, the reading occurs in the previous folder, it has to say the folder recently called.
Note : The [RET] tag has only one level of return. It is always the previous played folder that will be the
returned folder.
●
[SEQ]
or
[RND]
- Specifies sequential playback mode of the current folder. By default or without parameter,
the folder is read in a random mode.
[SEQ]: reading in a numerical order
[RND] or without any parameter : reading in a random mode
Example:
001 [SEQ]: read folder 001 in a sequential numerical order and stop at the end of the folder.
002[RND][J002]: reading of the folder 002 in a random mode and in a loop.
003[J001]: reading of the folder 003 in a random mode then jump to folder 001.
By choosing [SEQ] you select the sequential mode, meaning a reading in a defined order. The sorting is
made through a numerical order it has to say in the order of the numeros of the names of the files. The
files in the folder can be numbered from 001 to 999.(see next chapter related to files organisation within
the folders for the naming details).
In a defined order [SEQ], the files which are not numbered are ignored.
●
[RLxy] - Enable or disable the 2 output contacts
Each folder can directly activate different output contacts without any additional programming. You can
switch on a light, motors or any other actions depending on the folder read.
[RLxy]: x,y represent the 2 outputs (x=output 1 – y= output2) and can accept 3 values
x or y = 0 : output is disabled
x or y = 1 : output is enabled during the reading of the current folder
x or y = 2 : output is permanently activated. An order is necessary to inactivate outputs.
Example :
000[RL00][J000]: the folder 000 is read in a loop on powering on. Outputs are disabled.
001[RL10][J000] : enable output 1 when the reading of the folder 001 occurs then go back to folder 000
with disabling output 1 after reading folder 001.
002[RL02][J003] : enable pemanently the output 2 during the reading of the folder 002 then jump to folder
003 without disable the output 2.
Output contacts are switched from the beginning of the reading of the folder. If the files within the directory
have an activation or inactivation option of the outputs contact, the different outputs will evolve.
Note: If a folder is played in a loop, the outputs whose state is set to 1 will be re-triggered at each loop of
the folder. This mean a very short cut of the outputs designated to 1 at each loop-back.
Example:
001[J001][RL10]: Playback the folder 001 in a loop. At the end of the folder, output 1 will be deactivated
then reactivated immediately.
