ENG
ENG - 33
FAULT
POSSIBLE CAUSE
REMOVING METHODS
Unsatisfactory washing result.
Water being hard. (Dirty, hard, etc.)
Adjust the amount of detergent based on
the instruction of detergent manufacturer.
Laundries distributed in your machine
nonhomogenously.
Spread your laundries in the machine
properly and homogeneously.
As soon as the machine is loaded with
water, water discharges.
The end of water discharging hose is
too low for the machine.
Set the water discharging hose on appropriate
height. (**)
No water appears in the drum during
washing.
No fault. Water in the non-visible part of the
drum.
-
Laundries have detergent residues on them.
Non-dissolving particles of some detergents
may adhere to your laundries as white
spots.
Perform an extra rinsing by setting your
machine to “Rinsing” programme, or clean
the spots using a brush after your laundries
dries.
Grey spots appear on the laundries..
The reason for this spots may be oil, cream
or ointment.
Apply the maximum amount of detergent
instructed by the detergent manufacturer
in the next washing operation.
Wringing operation is not performed or runs
late.
No fault. Unbalanced load control system
has been activated.
Unbalanced load control system will try to
spread your laundries homogeneously.
Wringing operation will start after spreading
your laundries. Put your laundries in the
machine homogeneously in the next washing
operation.
(**) See the chapter regarding installation of your machine.