Hyundai VC 615B, Инструкция по эксплуатации, Страница: 35 / 56

ENG
ENG - 35
Removing the Telescopic Tubes and Accessories
To remove the telescope tube and accessories, hold each piece tightly and pull firmly apart.
OPERATION
Unwind the length of power cord required, then position the power cord so that it is not likely to
be walked on or pinched by things placed on or against it, finally insert the plug into the power
socket. A YELLOW mark on the power cord indicates the maximal cable length. Do no extend
the power cord beyond the RED mark. To retract the cord, press the cord rewinder button P7 .
ON / OFF Switch
1. Press the On/Off Switch button (P9) to switch the appliance ON.
2. To stop the machine, press the button P9 again.
Suction control
Adjust the Suction control knob on the curved handle to control the
suction.
The suction will be reduced with a larger air opening.
Suction power
The suction power can also be regulated through power adjust button P3.
Adjust suction power by moving the power adjust button to left or right.
Low vacuum power: For curtains and delicate fabrics
Medium vacuum power: For long-pile velour carpets and textile flooring
High vacuum power: For sturdy rugs and floors etc
After vacuum cleaning
Switch off the device when you have finished cleaning:
1. To do this press the foot button P9 on the device with your foot or by hand.
2. After this pull the mains plug from the socket.
3. To roll in the cable press foot pedal and hold it in position. The cable will be rolled back
automatically onto the installed cable drum and disappear completely into the device up
to the plug.
4. The floor nozzle can be kept attached to the vacuum cleaner for ease of storage after use.
Motor thermostat
This motor is equipped with a motor protective thermostat. If for some reason the vacuum
cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur
unplug the vacuum cleaner from the wall outlet and turn off switch. Change the dust bag or filter.
Allow the unit to cool for approximately 45 minutes. To restart, replug into wall outlet and turn
switch back on.