Hyundai RTC290SURIP, Инструкция по эксплуатации

Страница: 34 / 52

EN - 34
II) Encoding 1 disc
1. Place a CD with the printed side facing up inside the tray & then close the CD tray.
2. Press “ Record “ button (2) in CD stop mode, the Record LED indicator (24) will
fl ash and
USB LED indicator (17) light up. Press skip up button to select SD encoding if necessary, (It
must insert both USB/SD media). The SD LED indicator (19) will light up. Press the Record
button (2) again to con
fi rm record, the Record LED indicator (24) will change to light up and
USB or SD LED indicator will fl ash, system will start to playback the CD from fi rst track and
perform encode.
3. After completing of encoding whole disc, unit will stop record automatically.
Remark:-
- The recording speed is 1:1 and according to the actual plying time of the CD track
- The recording format is preset at – MP3 bit rate : 128 kbps, sampling rate : 44.1khz
- No song title will be recorded during encoding mode
- To interrupt the recording, Record button (2) to stop encoding.
III) Copying of MP3 file
If putting a MP3 disc instead of a CD-disc, the system will copy the fi les to the USB or SD/MMC
card. The operation procedures is same as CD encoding as stipulate on above, and the system
will switch to copying mode instead of playback mode if MP3
fi le being read.
Remark:
- The system will store the
fi le to USB source fi rst if both USB and SD slot are being occupied
by storage media.
- If press the “ Record “ button (2) during playback of USB or SD source, the fi le will copy from
USB to SD or SD to USB.
IV) File delete (on remote only)
You can delete the current MP3 fi le during playback of your USB/SD media by this function.
Press Delete button during USB/SD playback mode, the Rep/Ran LED indicator (23) will fl ash
slowly, press the Delete button again to con fi rm the delete function, the Rep/Ran LED indicator
(23) will fl ashing fast few second, the delete was performing then Rep/Ran LED indicator will go
off, it means delete was complete
B) Phono encoding
1. Set the Function switch (12) to “ phono “ mode.
2. Press “ Record “ button (2), the Record LED indicator (24) will
fl ash and USB LED indicator
(17) light up. Press skip up button to select SD encoding if necessary, (It must insert both
USB/SD media). The SD LED indicator (19) will light up. Press the Record button (2) again
to con
fi rm record, the Record LED indicator (24) will change to light up and USB or SD LED
indicator will fl ash, system will start to encode.
3. Start playback at phono for the track which you want to record to USB.
4. After
fi nish of recoding, press and the “ record “ button (2) once, the USB and Record LED
indicator will goes off and system stop the recording.
C) Track separation (by remote handset)
You can divide the recording music from phono/Aux to USB/SD track by trace during encoding.
Every time when press the “
“ (track separation) button once at remote handset during
encoding from phono/AUx to USB/SD, the system will generate a new track and continuous the
recording. The Record LED indicator (24) will
fl ash once, it mean the unit is creating a new track
successfully.