EN - 18
SETTING THE CLOCK
1) In standby mode, press and hold SET until the display flashes.
2) Repeatedly press HR to set the hours.
3) Repeatedly press MIN to set the minutes.
4) Press SET to confirm.
•
The hour and minute digits will stop flashing.
POWER ON/RADIO MODE
Press POWER to switch the unit on and enters the radio mode.
•
The radio frequency will briefly appear on the display and then return to clock time.
RADIO OPERATION
1) Press POWER to turn on the radio.
The default FM frequency or the last frequency you tune the radio to.
The default FM radio frequency is 87.5 MHz.
2) Press BAND once to enter the AM radio mode.
The default AM radio frequency is 522 kHz.
3) Repeatedly press BAND to select the desired radio band.
4) Adjust the volume by repeatedly pressing VOLUME ▼/▲.
5) Repeatedly press TUNING ▼/▲ to tune into the desired station.
Press and hold TUNING ▼/▲ for auto forward or backward radio station searching.
NOTE:
•
For the best FM reception, extend the FM aerial to its full length.
•
For the best AM reception, rotate the unit to the position giving best reception.
PRESETTING YOUR FAVOURITE RADIO STATION
Up to 10 FM and 10 AM radio stations can be preset.
1) Follow steps in „RADIO OPERATION“ and tune into the station that you wish to preset.
2) Press and hold SET for about 2 seconds, “
P01
” will flash on the display.
3) Press SET again to store the station.
4) Repeat steps 1 to 3 to store desired stations.
5) To listen to preset radio stations, press MEM repeatedly to select the desired radio station.
DUAL ALARMS OPERATION
Before setting the alarm time, make sure the Clock has been set.
SETTING ALARM 1 OR ALARM 2
1) In standby mode, press and hold AL1 or AL2 for 2 seconds.
The hour and minute digits will flash.
2) Set the alarm time by repeatedly pressing HR and MIN respectively.
Press and hold HR and MIN respectively for fast advance.
3) Press AL1 or AL2 again to select the alarm sound (OFF>BUZZER>RADIO in cycle).
CHECKING ALARM TIME
Press and hold AL1 or AL2 for 2 seconds, the alarm time will flash on the display.
To turn off the alarm, press POWER and the alarm will come on again at the set time on the
following days.
To cancel the alarm, repeatedly press AL1 or AL2 until the alarm indicator light goes out on the
display.
