Hyundai HYUAP235, Инструкция по эксплуатации

Страница: 22 / 52

ENG - 22
– Check the state of the supply cord regularly.
– Do not wind the supply cord around the device, this will extend its lifetime.
– The supply cord must not be damaged by sharp or hot objects, open flames, must not be
immersed in water or bent over sharp edges. Never put it on surfaces or let it hang over the
edge of a table or desk. Tripping over or pulling by the cord by for example children may cause
toppling of the device and serious injury!
– Turn the device off before unplugging.
– Do not let foreign objects to get into the device. High voltage inside the device may cause
electrical shock. Do not let children touch the device.
– Do not use the device outside!
– The air cleaner is an electrical device. If it is used in the presence of children, supervision by
a responsible adult person is necessary.
– Always place the device on flat, dry surface.
– Do not insert any objects into the openings.
– If you need to use an extension cord, it must not be damaged and correspond with the standards
in force.
– Never use the appliance if the power cord or fork is damaged, if it is not working properly,
if it has fallen on the ground and became damaged or if it has fallen in water. In such cases,
take the appliance to a professional service centre to check its safety and proper functions.
– The manufacturer is not liable for any damage cause by incorrect use of the device
(e.g. devaluation of food, injury, burns, fire ) and is not liable for the warranties in case of
breaching the precautions mentioned above.
– Maintenance and cleaning must be performed precisely according to this instruction manual.
– Apart form regular basic maintenance and cleaning (potential replacements) of filters should
any other maintenance and repair be done by a professional service centre personnel. Not
following this requirement may lead to warranty termination.
– Do not touch the metal dust collectors until the residual voltage discharges. Do so by connecting
the plates with a grounded object such as metal water piping, duct battery or radiator.
– Check and clean the dust collector regularly to avoid extensive accumulation of dust which
could cause a short circuit or fire.
WARNING – After cleaning the dust collectors with a common cleaning agent (without abrasives)
and water, it is necessary to leave it in a vertical position to dry thoroughly at least for 24 hours.
Only then you may put it back into the device. Water could stay in many places (e.g. in folds of
the plates) and could cause damage to the device. If the device is operated in a heavily polluted
environment, it is necessary to clean it more regularly.