Page 13
5.3.
Setting engine speed.
5.3.1.
After starting the engine, move the throttle
lever (1) clockwise to the HIGH position (2)
and check pump output.
5.3.2.
Pump output is controlled by adjusting
engine speed. Moving the throttle lever in
the HIGH direction (2) will increase pump
output, and moving the throttle lever (anti-
clockwise) in the LOW direction (3) will
decrease pump output.
5.4.
Stopping the engine.
Except for an emergency, avoid stopping the engine while pulling the
throttle lever.
After use, remove the pump drain plug, and drain the pump chamber.
Remove the filler cap, and flush the pump chamber with clean, fresh
water. Allow the water to drain from the pump chamber, then
reinstall the filler cap and drain plug.
5.4.1.
Move the throttle lever (1) to the LOW position and run the engine for a
half minute.
5.4.2.
Press the STOP button until engine fully stops.
5.5.
Adjusting the idling speed.
Warm up the engine before adjusting the idling speed.
5.5.1.
When the engine stop frequently at idling mode, turn the adjusting
screw clockwise.
6.
MAINTENANCE
Before cleaning, inspecting or repairing the water, make sure that the
engine has stopped and cooled down. Disconnect the spark plug
terminal
to avoid accidental engine starts.
6.1.
Daily inspection.
6.1.1.
Check all nuts and screws are securely tightened and no parts are missing.
6.1.1.16.
Before using machine replace any missing fixing nuts and screws.
6.1.2.
Check for leakage of fuel.
6.1.2.16.
Clear up all fuel spills immediately, repair any leaks before
starting the engine.
Ver 2
