Hyundai HY2161, Руководство пользователя

Страница: 7 / 12

Page 7
Jig saw can produce fine dust that could ignite in the presence of sparks or an open
flame. To avoid injury, always use the jigsaw in a well-ventilated area.
5.1. Switch action.
5.1.1. Before plugging in the tool, always check to see that the switch trigger works properly and
returns to the off position when released.
5.1.2. The switch can be locked for ease of operator comfort during extended use. Apply caution
when locking tool and maintain a firm grasp on tool.
5.1.3. To start the tool, simply pull the switch trigger. To stop
release the switch trigger.
5.1.4. For continuous operation, pull the switch trigger and then
push in the lock button.
5.1.5. To stop the tool from the locked position, pull the switch
trigger fully, then release it.
5.2. Speed Adjusting Dial.
5.2.1. The tool speed can be infinitely adjusted between 1,000 and
2,800 strokes per minute by turning the adjusting dial.
5.2.2. Higher speed is obtained when the dial is turned in the
direction of number 6, lower speed is obtained when it is
turned in the direction of number 1.
5.2.3. However, the appropriate speed may differ with the type or
thickness of the work piece. In general, higher speeds will allow
you to cut work pieces faster but service life of the blade will be
reduced.
5.3. Cutting bevel - Angle adjustment.
5.3.1. To adjust the bevel angle loosen the screws on the steel base with the provided Allen Key,
then adjust the base to desire angle, then to tighten the screws on the base by the Allen Key.