14
NOTICE
Substantial overloading will switch off the circuit breaker.
Exceeding the time limit for maximum power operation or slightly overloading the
generator may not switch the circuit breaker OFF, but will shorten the service life of the
generator.
Limit operation requiring maximum power to 30 minutes.
For continuous operation, do not exceed the rated power.
In any case, the total power requirements (VA) of all appliances connected must be considered.
Appliance and power tool manufacturers usually list rating information near the model number
or serial number.
4) AC Operation
①
Start the engine
②
Switch the AC circuit breaker ON.
③
Plug in the appliance.
Most motorized appliances require more than their rated wattage for startup.
Do not exceed the current limit specified for any one receptacle. If an overloaded circuit causes
the AC circuit breaker to switch OFF, reduce the electrical load on the circuit, wait a few
minutes and then reset the circuit breaker.
5) High Altitude Operation
At high altitude, the standard carburetor air-fuel mixture will be excessively rich. Performance
will decrease, and fuel consumption will increase.
High altitude performance can be improved by installing a smaller diameter main fuel jet in the
carburetor and readjusting the pilot screw. If you always operate the engine at altitudes higher
than 5000 feet (1500 meters) above sea level, have an authorized generator dealer perform
this carburetor modification.
Even with suitable carburetor jetting, engine horsepower will decrease approximately 3.5% for
each 1000 foot (300 meter) increase in altitude. The effect of altitude on horsepower will be
greater than this if no carburetor modification is made.
NOTICE
If a engine jetted for high altitude is used at a lower altitude, the lean air fuel mixture will
reduce performance and may over-heat and seriously damage the engine.
6. PRE-OPERATION CHECK
1) Engine oil
NOTICE
Содержание HG4000-A
Страница 1: ...1 EN LOW POWER GENERATING SET HG4000 A WARNING Read thoroughly the instruction manual before use...
Страница 8: ...8 Warnings on product Read them carefully before use the tool...
Страница 26: ...26 11 CIRCUIT DIAGRAM...
Страница 32: ...29...