Hyundai H-CMD7083, Инструкция по эксплуатации

Страница: 6 / 66

6
Pic. 1
Detachable control panel
Detaching the control panel
1. Press the OPEN button on the front panel. The panel will go down (pic. 1).
2. Push the panel to the left and then pull it towards you (pic. 2).
Attaching the control panel
1. Insert the left side of the control panel into the main unit (pic. 3).
Note: the control panel must be attached into the T-Joint.
2. Press the right side of the control panel until a “click” sound is heard.
3. Close the panel.
Caution:
DO NOT insert the control panel from the right side. It can damage the control panel.
The control panel can easily be damaged by shocks. After removing it, place it in a protective case
and be careful not to drop it or subject it to strong shocks.
The rear connector that connects the main unit and the control panel is an extremely important part.
Be careful not to damage it by pressing on it with fingernails, pens, screwdrivers, etc.
Note: If the control panel is dirty, wipe off the dirt with soft, dry cloth only. And use a cotton swab soaked in isopropyl
alcohol to clean the socket on the back of the control panel.
Electrical connections
Speaker wiring notes
Follow the above wiring diagram to install the head unit with new or existing speakers.
This unit is designed for use with four (4) speakers with an impedance between 4 Ohms to 8 Ohms.
An impedance load of less than 4 Ohms could damage the unit.
Never bridge or combine the speaker wire outputs. When not using four speakers, use electrical tape to tape the ends of
the unused speaker outputs to prevent a short circuit.
Never ground the negative speaker terminals to chassis ground.
Pic. 2
Pic. 3