5
Instruction manual
Program mode
Up to 20 tracks can be programmed for disc
play in any order or the same track can be
repeated up to 20 times.
• Before use, be sure to stop the CD by
pressing STOP button.
• Press PROGRAM button. The display will
show “P01” and “PROGRAM”. This indicates
that the set is now in memory programming
mode, at the first memory position.
• If you use an MP3 disc, press /FOLDER
or /FOLDER button to select a folder.
• Select a desired track by using
SKIP/
SEARCH and
SKIP/SEARCH buttons.
• Press PROGRAM button again to confirm.
The set will advance to next memory position,
the display will show “P02”. Repeat two steps
described above to enter additional memories
into the program if necessary.
• After the maximum of 20 songs (or less)
have been selected as described above,
press PLAY/PAUSE button to start playing the
programmed tracks.
• The “PROGRAM” symbol will remain on
to indicate that you have saved a program-
memory (sequence).
• To check the program you stored, after
the programming is completed, in stop mode
press PROGRAM button (for MP3 discs -
after pressing PROGRAM button, press
/FOLDER or /FOLDER button to see the
folder number), then press
SKIP/SEARCH
button repeatedly to see all programmed track
numbers.
• The program memory will be cleared when
you press STOP button twice, open the disc
compartment door or turn off the disc player or
power supply.
Good quality sound is guaranteed only
when playing licensed MP3 discs.
“Dynamic Bass Boost” system
For increased bass at all volume levels,
set BASS BOOST switch to ON position for
an emphasized bass sound. Set it to OFF to
disable the function.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or is
being run exclusively on the alternative power,
remove the batteries to avoid leakage and
damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture and dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• When pick up the CD disc, always hold the
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
Accessories
Radio player
1 pc
Power cord
1 pc
Instruction manual
1 pc
Warranty card
1 pc
Consumer information
1 pc
