5
Instruction manual
Recording
Recording from radio
• Set FUNCTION switch to RADIO position.
• Set BAND switch to the needed band
position.
• Tune to the desired station by turning
TUNING control regulator.
• Insert a blank cassette into cassette
compartment.
• Press button. The recording will start.
• For brief interruption press button. To
resume recording press the button again.
• To stop recording press
button.
Recording from CD
• Set FUNCTION switch to CD/MP3
position.
• Insert a cassette in the cassette
compartment.
• Start the desired track playback.
• Press button. The recording will start.
• For brief interruption press button. To
resume recording press the button again.
• Press
button when finished. Then
stop CD playback by pressing (FOLDER)
STOP button.
• You may want to monitor during
recording. You can adjust the sound with
VOLUME regulator. These adjustments do not
affect the content of recording.
• This deck is not suitable for recording
on CHROME (IEC II) or METAL (IEV IV) type
cassettes. For recording use NORMAL type
cassette (IEC I) on which the tabs have not
been broken.
• At the very beginning and end of the
tape, no recording will take place during the
7 seconds, when the leader tape passes the
recorder heads.
• When in process of recording or playback
the end of the tape is reached, the tape stops
automatically and the relevant button is released.
Dynamic bass boost system
• For increased bass at all volume levels,
press DBBS button to boost the low frequency
tone for an emphasized bass sound.
Maintenance and care
• Check your batteries regularly, old or
discharged batteries should be replaced. If the
unit is not going to be used for some time or
being run solely on the alternative power, remove
the batteries to avoid leakage and damage.
• Electronic products of this kind should
never be subjected to moisture or extreme
temperatures.
• Do not use the unit in places where it can
be exposed to water, moisture or dust.
• If necessary, clean the unit with a piece of
cloth dampened with water only (be sure the
AC power cord is disconnected from the power
supply).
• The heads and capstan are in constant
contact with the moving tape. Use a small
cotton bud with alcohol or special tape head
cleaner to clean these parts. Never touch the
heads with anything metallic. Clean the heads
and the capstan after approximately 50 hours
of last operation or on average once a month.
• When pick up the CD disc, always hold the
edge of the disc, never touch the surface of the
disc, it would scratch the disc surface and may
occur sound distortion or raise reading problem.
Cassette erase protection
• To prevent accidental erasing of a
cassette, simply break off the two plastic tabs
located on the cassette tape’s rear side.
• When a cassette with removed plastic
tabs is inserted, the recording button cannot be
pressed.
• If a cassette is to be erased and re-
recorded at a later stage, simply cover the
holes on the cassette where the tabs were
removed, with a piece of strong adhesive tape.
All manuals and user guides at all-guides.com
Содержание H-1422
Страница 13: ...All manuals and user guides at all guides com...
