Hyundai EQUUS 2016, Руководство пользователя

Страница: 150 / 477

Programming HomeLink
®
Information
• When programming a garage door
opener, it is advised to park the
vehicle outside of the garage.
• It is recommended to replace the
hand-held transmitter battery of the
device being programmed to
HomeLink
® for quicker training
and accurate transmission of the
radio-frequency signal.
• Some vehicles may require the igni-
tion switch to be turned to the sec-
ond (or "accessories") position for
programming and/or operation of
HomeLink
® .
• In the event that there are still pro-
gramming difficulties or questions
after following the programming
steps listed below, contact
HomeLink
® at: www.homelink.com
or 1-800-355-3515.
Standard programming
To train most devices, follow these
instructions:
1. For first-time programming, press
and hold the two outside buttons,
HomeLink
® Channel 1 and
Channel 3 Buttons, until the indi-
cator light begins to flash (after 20
seconds). Release both buttons.
Do not hold the buttons for longer
than 30 seconds.
2. Point the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink
®
button
you wish to program while keeping
the indicator light in view.
3. Simultaneously press and hold
both the HomeLink ® and handheld
transmitter buttons. DO NOT
release the buttons until step 4 is
completed.
4. When continuously pressing the
buttons, the red Indicator Status
LED will flash slowly and then rap-
idly after HomeLink
®
successfully
trains to the frequency signal from
the hand-held transmitter. Then,
release both buttons.
5. Press and hold the just-trained
HomeLink
®
button and observe
the red Status Indicator LED. If the
indicator light stays on constantly,
programming is complete and
your device will activate when the
HomeLink
® button is pressed and
released.
6. To program the remaining two
HomeLink ® buttons, follow the
steps 2 to 5.
i
3-55
Convenient features of your vehicle
03