Hyundai CRMD 7759 B, Инструкция по эксплуатации

Страница: 103 / 148

EN
EN - 103
DEVICE CONNECTIONS
Notes of connection
• Assembly is necessary to do in the service
center.
• The car radio must not be installed in the
excluded zone of head impact!
• This unit is designed to be used in a ve -
hicle with a 12-volt battery and
• negative grounding. Before installing this
unit to a recreational vehicle, a bus, or
a truck, make sure the battery voltage is
appropriate for this unit to be used, other -
wise, install
• a transformer by professional to convert
• the output voltage to 12V.
• To avoid short circuit in the electrical
system, ensure that the negative battery
cable is disconnected before installation.
• To prevent short circuit in the wiring and
damaging to this unit, secure all wirings
with cable clamp or adhesive tape. Route
the wirings in a secured, out of heating pla -
ce without touching any moving parts such
as gear shift, handbrake, and seat rails to
prevent the wiring insulation being melted /
wore off.
• Never pass the yellow power cord through
the installation hole into the engine
compartment and connect to the car
battery. Otherwise, a high possibility of
serious short circuit to the electrical system
may be occurred.
• Replacing a new fuse with 15A rating when
the old one is broken, using no fuse or fuse
with improper rating may cause damage
to this unit or even fires. If a proper fuse is
installed and electrical problems still occur,
please contact with any professional car
shops for inquiry.
• DO NOT connect other equipments
with the car battery to avoid battery
overheating.
• Please make sure all the wiring
connections & the cables of the speakers
are well-insulated. Otherwise, this unit may
be damaged by short circuit.
• If there is no ACC available, Please
connect ACC lead to the power supply with
a switch.
• If an external power amplifier is connected,
please don’t connect P.CONT lead to the
power lead of the external power amplifier,
otherwise, electric spark or other damage
may be resulted.
• Never ground the speaker output
to prevent the damage to the built-in power
amplifier.
• The minimum rating of the speakers
connected to this unit is 50W with 4 to 8Ω
impedance.