Ensure that the T-Anchor is fully seated to a vertical position.
Use caution when tightening the T-Anchor so you do not
damage the plastic panel.
N
O
T
E
1. By hand, insert the provided T-anchor with spigot; tighten until snug and
no gaps are found.
2. Align the T-anchor to a vertical position shown in the drawing.
3. Repeat for opposite side.
N
O
T
E
1. Check for movement or gaps between the T-Anchor and rear plastic
sill panel.
2. If movement or a gap exceeding 1.0mm is found, further tighten using
1/4 ~ 1/2 increment turns until the T-anchor is seated to a horizontal
position.
3. Repeat for opposite side.
7
8
Ensure that the T-Anchor assembly is fully seated to a
horizontal position.
Note: a <1.0mm gap will still exist because of the shoulder of
the self tapping screw.
N
O
T
E
1. Check for movement or gaps between the T-Anchor and trunk liner.
2. If movement or a gap exceeding 1.0mm is found, further tighten using
1/4 ~ 1/2 increment turns until the T-anchor is seated to a horizontal
position.
3. Reattach the rubber seal from step 1 by firmly pushing along the
entire edge to ensure it is correctly seated.
4. Repeat for the opposite side.
N
O
T
E
1. Locate the lower plastic grommet as shown. By hand, rotate the
grommet counter clockwise to remove, then discard the grommet.
2. Repeat for the opposite side.
HYUNDAI Genuine Accessories
5
6
5INS131600HI
Revision Date
06/17/2014
Page 4 of 7
