Hyundai power products HYMD500, Инструкция по эксплуатации, Страница: 30 / 40

30
Maintenance & Care
IMPORTANT - Routine and accurate
maintenance is essential for maintaining
original machine safety and performance
levels.
Always stop the engine and unplug the spark
plug before doing any repairs or maintenance.
Only use original spare parts: The
use of non-original and/or incorrectly fitted
parts will jeopardize the safety of the machine,
may cause accidents or personal injuries for
which the Manufacturer is under no
circumstance liable or responsible.
1. Wear strong protective gloves before
cleaning, maintaining or making adjustments
to the machine.
3. Paint on internal chassis parts may start to
flake over time due to abrasive action of cut
grass. If this happens, you should touch-up
with rust-proof paint to prevent rusting that
could corrode the metal. You can also use a
light oil or silicone spray to prevent rust.
4.
If you need to access the lower part of the
scarifier, you must tilt the scarifier with the air
filter facing up, following the relevant
instructions, making sure that the machine is
stable before performing any interventions.
5.
Make sure not to drip petrol onto the plastic
parts to prevent damaging them and remove
all traces of spilled petrol immediately. The
warranty will not cover damage to plastic
parts caused by petrol.
6.
It is highly recommended to change the
engine oil regularly. This will ensure the
machine will function properly over time. The
oil can be discharged at a specialised
servicing centre, or by using a syringe to
suction the oil out through the filler spout,
bearing in mind you may need to repeat the
operation several times in order to
completely empty the tank. Remember to
top-up with oil before using the machine
again.
7. Lubricate the wheel bearings with a suitable
lubricant.
CAUTION - DO NOT use a hose pipe or
pressure washer to clean the engine. Water
can damage the engine or contaminate the
fuel system.
Routine Maintenance
!
!
Preventive Maintenance
STEP 1
Turn off the engine and disengage all
command levers. The engine must be cool.
STEP 2
Keep the engine’s throttle lever in its SLOW
position and remove the spark plug wire
from the spark plug and secure.
STEP 3
Inspect the general condition of the machine.
Check for loose screws, misalignment or
binding of moving parts, cracked or broken
parts, and any other condition that may affect
its safe operation.
STEP 4
Use a soft brush, vacuum or compressed
air to remove all contaminants from the
machine. Then use high quality light oil to
lubricate all moving parts.
STEP 5
Check the spark plug wire regularly for signs
of wear, and replace when needed.